Nov/090
More carpeting and Track Map Holder
Wow, I finally got around to doing some more work on the cockpit. I suddenly had an urge to finish the carpet, so I spent a couple of hours finishing it tonight.
Before starting this I fixed in the rear brackets on the wheel shelf, I forgot to secure this before.
I chose to do the bottom section first off, measuring the length and width needed and leaving enough for an inch of overlap on each side. I was only carpeting up to the edge of the carpet gripper, where the pedals start. Nothing else is visible, from either inside or out.
I was more accurate than when I did the back half, so cutting things too small wasn’t an issue. After fixing the bottom piece, I chose to do the large vertical face at the bottom. This would overlap the extra inch from the bottom section and be trimmed at the edge for a clean line.
Next up, I did the sides, inside. These sections would go over the brackets for holding the wheel shelf. Again, I left an inch of overlap. This would be trimmed to the edge afterwards. Next I wanted to cover the vertical face going up the sides. I used one rectangular piece for either side. This would overlap the sides inside and leave no line visible.
Next, I needed to make custom shapes to fit in the top corners (see images). I did some brief measuring and ended up with a shape that somehow looked like the cockpit itself! I got these two stuck in.
Finally I decided to cover the wheel shelf. In hope it might deaden the sound of my wheel just a bit. There were a few tiny little gaps in the material so I just used some of the offcuts and filled them. Once the glue is perfectly dry I will brush off any excess glue that has got onto the front of the carpet.
Very happy with the final result of the carpeting, like the back half, it really absorbs the corners, it’s great to sit in.
Finally, just for a little touch, I added a plastic Business Card Pocket. This would hold a track map.
Not much more left to do now. Decals, Wheel, Final touch ups and hopefully two button boxes if someone can make them for me!
I’m thinking of covering the wheel cowling in the carbon fibre I’ve got left over. It’s either that or painting it.
Aug/090
Materials Received
-
- Carbon Fibre Vinyl
-
- Coach Bolt
-
- Transparent Wallets
-
- CF Vinyl Adhesive Back
-
- Spray Adhesive & Carpet
After ordering the materials last week, I’ve been pleasantly surprised to see them all arrive by today. I got the last item – the Carbon Fibre Vinyl.
I’ve already put the Aluminium to good use. The carpet was spot on, the adhesive was about 5 times bigger than it looked in the picture and the CF Vinyl is just as I had expected.
I’ve attached pictures of the materials and also of the bolts I purchased for the button box buttons. I also purchased a pack of transparent business car holders/sleeves. One of these will be ideal for putting a track map into and sticking it on the side of the cockpit. They have self adhesive on the back too.